Skip to content
Custom mouldGermanyIllustrative

New multi-joint glide mould for a German pike brand

A three-section glide built from a hand-carved blank, with two rounds of hinge and weight adjustment.

Wooden glide bait body being finished in a workshop

Project note

The brand wanted a wider glide than their current bait, without losing the slow sink rate their customers fish. Our tooling team cut the mould around a revised hinge position, then tuned internal ballast across two sample rounds until the sink rate matched the brief. The outcome is a signed-off master sample and a mould that stays in the buyer's name for future runs.

Back to all cases
苏ICP备05069715号-1